The edge connector on the micro:bit is used to connect to external circuits and components.
There are 25 strips/pins including 5 rings for using with 4mm banana plugs or crocodile clips. 3 of these rings are for general purpose input and output (GPIO), and two are connected to the micro:bit power supply.
The small strips in between are also connected to various signals, and with the right connector you can get access to quite a few different signals.
Only the pins on the front are connected to signals. The back rings are connected to the front rings, but the back small strips are unconnected.
Edge Connector Pins
The PCB connector is an 80 way * 1.27mm pitch double sided connector.
You can buy this connector from a number of sources.
At a pinch, it is also possible to use an old PCI edge connector from a PC motherboard, as the pitch is the same (but it is slightly wider).
There is a good mechanical data-sheet for the right angle PCB edge connector available from Cool Components.
Edge Connector Data-Sheet
2D CAD drawing This drawing has all the key micro:bit dimensions, including the pin spacing of the various pins of the edge connector on the micro:bit board.
STL file This file can be used with 3D printers.
Can You Find a Better Connector?
There are a number of suppliers of edge connector for the micro:bit, in various forms, such as a right angle through-hole, a stand-up through-hole and a stand-up surface mount. There are a wide range of connector manufacturers that sell thousands of different types of connectors.
There are also some nice ideas that have surfaced in the community such as using just the right size of countersunk or cheese-head bolt, or even 3D printed inserts.
Can you help to find or design a better connection solution to the micro:bit edge connector? Share your designs and discoveries with us!
Third Party Connnectors Add your connector to our list
|Cyclonn||Cylconn 90 degree connector, Cylconn 180 degree connector|